Search:

Type: Posts; User: MIG; Keyword(s):

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    4
    Views
    120

    The pcv is the only place oil could get in; a...

    The pcv is the only place oil could get in; a small amount of vapour can condense. Did you inspect the valves while you had the intake off?

    I will be doing my valve cover gasket in the next few...
  2. Thread: Weird MFI symbols

    by MIG
    Replies
    3
    Views
    179

    My old cluster would never show the icon for...

    My old cluster would never show the icon for USB-sourced devices; it would show the same little square box.
    I was messing around, and I updated the firmware on the cluster, it added the missing USB...
  3. Replies
    2
    Views
    105

    The release switch in the badge is grounded to...

    The release switch in the badge is grounded to the point behind the left boot liner; the other wire goes directly to the CCM (Yellow grey cable at the left connector harness)

    Power for the motor...
  4. What plugs or connectors don't fit? It might be...

    What plugs or connectors don't fit? It might be just a case of getting a different connector.

    A few pictures would help with diagnosing the issue.

    Usually, a trailer controller just needs...
  5. Thread: Rear View Camera

    by MIG
    Replies
    2
    Views
    154

    I would be going with Kamold's suggestion but...

    I would be going with Kamold's suggestion but would focus on the coax or fakra connector due to this camera module being all in one, e.g CAN bus goes directly to the camera, and OBDeleven can still...
  6. Replies
    8
    Views
    197

    If you run an output test in VCDS, you should be...

    If you run an output test in VCDS, you should be able to test each fan.
    I would also check to see if the fans spin freely (With the battery disconnected!) the error only shows to be triggered once.
  7. Replies
    8
    Views
    197

    No mention of draining to coolant, so it must be...

    No mention of draining to coolant, so it must be just clipped, I will PM you the PDF :cool:
  8. Replies
    8
    Views
    197

    You are in luck; it's not a bumper-off job...

    You are in luck; it's not a bumper-off job :banana:

    Remove the airbox intake duct
    Remove the four screws on the fan support tray.
    Unclip the coolant hose from the support.
    Disconnect the power...
  9. Replies
    19
    Views
    2,504

    This week's update. My Aliexpress RVC failed...

    This week's update.

    My Aliexpress RVC failed after a few months, so I had to move forward with the RVC replacement.

    - Installed a 7N0907441B Highline controller.
    - Removed the camera module...
  10. Replies
    8
    Views
    197

    If it's anything like what it was on the VW Up! I...

    If it's anything like what it was on the VW Up! I did a while back; you need to pull the bumper, AC condenser, then pull the whole radiator assembly out to get to the fans.

    I will check the...
  11. Thread: Hello.

    by MIG
    Replies
    3
    Views
    188

    SA Welcome! It might still be good to check the...

    Welcome!
    It might still be good to check the gateway version you have to see if it's a known version to cause battery drain.

    Do an auto-scan and check the address 19 details; it should look like...
  12. Thread: R36 - My first VW

    by MIG
    Replies
    4
    Views
    164

    VIC Welcome! The R36 wagons are such a nice car, and...

    Welcome! The R36 wagons are such a nice car, and you got the best colour too :D
  13. Replies
    3
    Views
    363

    What are you looking to do? Update the software...

    What are you looking to do?
    Update the software of the ECU
    Or modify the existing software e.g tuning?

    Sent from my SM-N960F using Tapatalk
  14. It might be the cables that run via the flex...

    It might be the cables that run via the flex joint in the hatch; if they have rubbed through and are shorting, you may get both the message for the rear brake light and the boot latch poping.

    I...
  15. Replies
    433
    Views
    153,165

    Switching the mic to a 3BD 035 711 looks to have...

    Switching the mic to a 3BD 035 711 looks to have mostly solved the issue, it echos at the beginning of a call for 1 - 2s, then no more for the rest of the call.

    It might be some weird AGC kicking...
  16. Replies
    12
    Views
    1,320

    I think that part should be 1H0 521 349 shared...

    I think that part should be 1H0 521 349 shared with the R32
  17. Replies
    12
    Views
    1,320

    Looks like 1J0 521 307 D is the current version...

    Looks like 1J0 521 307 D is the current version of that part.

    Have you tried the VW dealer at all? Sometimes, they are the only place that can get a weird part like that.

    You could also try...
  18. Replies
    19
    Views
    2,504

    This weekend's project was upgrading to the B8's...

    This weekend's project was upgrading to the B8's borderless mirror.

    I am very happy with the result; the mirror is faster in responding to lights and has and much nicer fade in and out.

    Step...
  19. Replies
    19
    Views
    3,383

    I was just going off the prices I saw on...

    I was just going off the prices I saw on Aliexpress, I can not comment on the quality of them as I have not used them before.

    The after-market CVBS camera are pretty easy to install, just remove...
  20. Replies
    15
    Views
    812

    More and more RNS units are failing now, and you...

    More and more RNS units are failing now, and you might be better off retrofitting again to a newer unit.

    A good workshop should be able to run a scope on the CAN bus and see what module is not...
  21. Thread: Kamold's R36

    by MIG
    Replies
    303
    Views
    101,584

    Awsome work Kamold, I was literally just...

    Awsome work Kamold,

    I was literally just looking the other day to see if that sub would fit in the spare tyre.

    Could you please share the PN on the 12-channel amp, I guess there are parameters...
  22. Replies
    15
    Views
    4,725

    That code is for a Right Low Beam Reflector Motor...

    That code is for a Right Low Beam Reflector Motor (V295)

    Open up the back cover of the light and check if any of the wires look damaged or frayed; I have heard of these having the insulation fail...
  23. Replies
    145
    Views
    36,824

    That paint job looks awesome, good work on...

    That paint job looks awesome, good work on getting the colour right.
    Where did you get the 2k colour clear mix from? I have used 2k clears in a can before and you can get a week or two out of them...
  24. Replies
    5
    Views
    239

    The original code on the OEM modules, be that...

    The original code on the OEM modules, be that Bosch, TRW, Hella, etc will be under NDA with the staff that wrote it.
    The professional groups that make ECU tunes put many hours into...
  25. Get a 12v test lamp to hook it up between the...

    Get a 12v test lamp to hook it up between the ground and the trigger wire, it should light up when you put the car in reverse.
Results 1 to 25 of 108
Page 1 of 5 1 2 3 4
| |