Search:

Type: Posts; User: kamold; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    4
    Views
    112

    Pics or it didn't happen. Jokes aside - post a...

    Pics or it didn't happen.
    Jokes aside - post a few pics as they tend to tell a thousand words.

    What does 'quite a bit puddle mean'? Where exactly is the oil?

    The amount and location is...
  2. Replies
    2
    Views
    142

    Wiring harness is damaged or the camera itself is...

    Wiring harness is damaged or the camera itself is faulty (more likely the former).
  3. Replies
    7
    Views
    508

    The Harman Kardon system has an external amp. I...

    The Harman Kardon system has an external amp. I suspect that the OP's car has the config on the MIB for a car that is supposed to have an amp like yours.
  4. Replies
    7
    Views
    508

    'Sounds' like it may have the incorrect dataset...

    'Sounds' like it may have the incorrect dataset loaded on it. Might be setup for an amplifier so is outputting line level instead of speaker level.
    If that is the case then the dealer would be able...
  5. Replies
    3
    Views
    362

    A lot of tuners will mark a block on the flash...

    A lot of tuners will mark a block on the flash unreadable so that you can't pull it over OBD.
    Then you'll need to bench the ECU to get it into boot mode to be able to read the whole of flash. Which...
  6. Replies
    679
    Views
    153,738

    You'll need vcp or find someone local who has it....

    You'll need vcp or find someone local who has it.

    Sent from my SM-G781B using Tapatalk
  7. Replies
    15
    Views
    811

    I'm in the north-west. Can update the gateway...

    I'm in the north-west. Can update the gateway software so that it properly supports gen3 radios.
  8. Replies
    15
    Views
    811

    Probably a bit of both. Update will take 10mins....

    Probably a bit of both.
    Update will take 10mins. If that doesn't fix it then it's a basic electrical consumer hunt which you'd hope an auto elec would be able to perform.
  9. Replies
    15
    Views
    811

    That's an MIB screen only suitable for an MQB...

    That's an MIB screen only suitable for an MQB car. Not PQ. If installed in an MQB car still needs the MIB unit in the glovebox to run it.
    There is a suitable PQ unit Discover Media/Composition...
  10. Thread: Kamold's R36

    by kamold
    Replies
    303
    Views
    101,556

    Sorry meant to put the PN in there (post...

    Sorry meant to put the PN in there (post updated).
    Yes it needs params (can supply xml). There is no CP for PQ amps.
  11. Thread: Kamold's R36

    by kamold
    Replies
    303
    Views
    101,556

    Have been very slack with updates sorry. A...

    Have been very slack with updates sorry.

    A very brief list to get up to date, in no particular order:

    7N0 (Bosch MRREvo) radar upgrade
    - same radar as used in Golf 7.5, B8 Passat etc. Also...
  12. Replies
    5
    Views
    239

    Cruise control (regular or ACC) is controlled by...

    Cruise control (regular or ACC) is controlled by the drivetrain co-ordinator which is in the ECU software.
    Then it will depend which ECU the car has (Bosch or Siemens/Continental).
    So you're likely...
  13. Replies
    5
    Views
    239

    Pretty broad question...there are dozens of...

    Pretty broad question...there are dozens of modules in a car each running hundreds to 10s of thousands of lines of code.
    Want to be a bit more specific?
  14. Replies
    433
    Views
    153,049

    Yes factory mic from RNS510 days.

    Yes factory mic from RNS510 days.
  15. Replies
    433
    Views
    153,049

    Make sure voice enhancer is turned off. I have...

    Make sure voice enhancer is turned off.
    I have Dynaudio and don't have any echo issues.
  16. Replies
    19
    Views
    3,369

    Composition Media or Discover Media (the nav...

    Composition Media or Discover Media (the nav version) are much better than RCD330.
    Factory amp support is in built. As is steering wheel controls, MFD support (for BAP displays), better audio...
  17. Replies
    11
    Views
    962

    Fewer adapters = fewer problems. Paring it back...

    Fewer adapters = fewer problems. Paring it back to the absolute minimum that's required for full functionality will be helpful.
  18. Replies
    11
    Views
    962

    OEM radios are started by a message from the...

    OEM radios are started by a message from the gateway triggered by the BCM/CECM from driver's door being opened.
    That way they are already at least partially booted up by the time the car is...
  19. Replies
    1
    Views
    515

    Are you trying to load VW firmware onto a SEAT...

    Are you trying to load VW firmware onto a SEAT unit? If so that's your issue. The hardware ID of the unit is not supported.
    If you are trying to load just EU maps it appears that you might have a...
  20. Amazing work as always Frank! The state of that...

    Amazing work as always Frank!
    The state of that car when it came to you is truly shocking....hope the owner appreciates the transformation you've done :)
  21. Replies
    2
    Views
    348

    Very common failure. If it's under warranty get...

    Very common failure.
    If it's under warranty get it replaced.
    Harware revision 51 and above on the screens are better, but still not immune to this issue.
  22. Replies
    5
    Views
    323

    Yeah the running the AC for a while before...

    Yeah the running the AC for a while before getting in is as good a reason as heating up a frozen car.
    Given we no longer make cars here it's likely the rules will have to continue to harmonize with...
  23. Replies
    5
    Views
    323

    A couple of issues (apart from legalities, I'm...

    A couple of issues (apart from legalities, I'm not sure it's road legal here, might want to check) - US remotes operate on a different frequency to RoW so those remotes won't be able to be paired...
  24. Replies
    3
    Views
    432

    Need to check the fault code from the AFS module...

    Need to check the fault code from the AFS module address 55. It will tell you what the issue is.
  25. Replies
    10
    Views
    724

    Probably

    Probably
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
| |