Search:

Type: Posts; User: ak77; Keyword(s):

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    1,224

    Thanks mate I'll give this a go. Looks very hard...

    Thanks mate I'll give this a go. Looks very hard to take off plastic components.
  2. Replies
    1
    Views
    1,782

    Carplay Upgrade for VW Touareg – Paul O'Brien...

    Carplay Upgrade for VW Touareg – Paul O'Brien
  3. Replies
    4
    Views
    1,224

    VW Touareg - rough start- 2017 V6 Tdi

    Hi There,

    I have noticed an issue with my 2017 TDI V6 Touareg at start-up, which has a very rough idle and started to shake.
    I have only started noticing this at a cold start. I scanned the car...
  4. Thanks, guys, I found the MDI unit I'm guessing...

    Thanks, guys, I found the MDI unit I'm guessing that is it.
    I do have a follow-up problem with the Defective can gateway I will post on a separate line.
  5. Where to find BT module? Alltrack Passat, V6 FSI , B7

    Hey there,

    Just wondering if anyone knows the location of the Bluetooth module in the 2013 Alltrack V6 Passat?
    It's not under the driver's seat and I'm not sure if RCD510 has it inbuilt.
    ...
  6. Replies
    5
    Views
    13,287

    Did you ever confirm the actual issue?

    Did you ever confirm the actual issue?
  7. Look at the starter motor , then battery ...

    Look at the starter motor , then battery


    Sent from my iPhone using Tapatalk
  8. Just like to add to this , as owner of GTd BMN...

    Just like to add to this , as owner of GTd BMN Mk5 I had lots of experience with G28 sensor and other mentioned components.

    Quickly just on price of VCDs cable is not 300 but in $600US

    G28...
  9. Replies
    18
    Views
    7,839

    Hey I had the same problem , but I fixed the...

    Hey I had the same problem , but I fixed the issue after re-setting Radio to factory state. I have other problem now
    ; station list wont stay programmed . They clear every time car turns off. Any...
  10. Replies
    5
    Views
    1,479

    Hey , just look at the log books and see when the...

    Hey , just look at the log books and see when the service last took place on the DSG around 70K mark. Would be the more expensive one $1000 +

    It helps to know what car is it ? Model engine number...
  11. Replies
    451
    Views
    331,432

    Sticky: Hey , the plugs should be standard over the...

    Hey , the plugs should be standard over the generation span. Only thing that is different that certain modules and protocols wont operate on older HEX cable form cars 2017 and onward.
  12. Thread: Reboot RCD510

    by ak77
    Replies
    7
    Views
    19,842

    Hey guys, I have RCD510 Delphi version.. Never...

    Hey guys, I have RCD510 Delphi version.. Never could unlock the CD changer.
    Anyone know how.

    Cheers

    Al
  13. Sticky: Hey dude , I'm having exactly the same issue. I...

    Hey dude , I'm having exactly the same issue. I have tested my injectors in my Audi BMN and they are fine. Looking into Sensors that cheat engine of its oxygen reading. There are 4 that can cause...
  14. Replies
    13
    Views
    6,281

    To keep this simple, I know lots of you guys...

    To keep this simple, I know lots of you guys looked at the youtube videos :) but when I took the DPF off , I could see through the cells.
    Anyway , Im gone past the DPF itself. Looking into...
  15. Replies
    13
    Views
    6,281

    I didn't chemically clean the DPF , noting comes...

    I didn't chemically clean the DPF , noting comes out of it no dust.
  16. Replies
    13
    Views
    6,281

    Hey, I took the entire thing DPF off and piping...

    Hey,
    I took the entire thing DPF off and piping . No soot what so ever , normal ash level - minimal dirt.
    Measuring blocks fluctuate and as I don't relative comparison indicator I can not tell....
  17. Replies
    13
    Views
    6,281

    Also guys , DPF is clean as I have inspected the...

    Also guys , DPF is clean as I have inspected the unit .
  18. Replies
    13
    Views
    6,281

    Umai , steering angle sensor resets it self every...

    Umai , steering angle sensor resets it self every time car goes to drive . It only registers on false start if there is an issue.
    That part is good. Not a problem.
  19. Replies
    13
    Views
    6,281

    Hey guys, thanks for the reply. I have run the...

    Hey guys, thanks for the reply. I have run the car after start with the diesel spray. DPF error goes away immediately as you start driving but the car goes in limp mode in 20min time. This suggest...
  20. Replies
    0
    Views
    780

    BNM ENGINE issue GTD /AUDI A3

    VW golf mk5 GTD /AUDI A3 _BMN engine (2007) - HELP

    Hi guys,
    I need help with my A3 Diesel Audi BNM engine. It has number of issues it seems but not logging all of them in the scan.
    ...
  21. Replies
    13
    Views
    6,281

    Here is the scan. VCDS -- Windows Based...

    Here is the scan.

    VCDS -- Windows Based VAG/VAS Emulator Running on Windows XP x86(VMWare)
    VCDS Version 18.2.0.3
    Data version: 20180212 DS287.0
    Ross-Tech: Home


    ...
  22. Replies
    13
    Views
    6,281

    AUDI A3 _BMN engine (2007) - HELP

    Hi guys,
    I need help with my A3 Diesel Audi BNM engine. It has number of issues it seems but not logging all of them in the scan.
    1. Glow plugs heater Spiral icon flashing...
  23. Replies
    6
    Views
    3,697

    Let us know you how you go

    Let us know you how you go
  24. Replies
    6
    Views
    3,697

    Forgot to mention , obviously you will need VCDS...

    Forgot to mention , obviously you will need VCDS cable and software. Not cheep.

    Al
  25. Replies
    6
    Views
    3,697

    Hey , you will most likely be able to refit all...

    Hey , you will most likely be able to refit all the parts mechanically, but hard part isn't retrofitting the box.

    Mechatronic unit has to correspond to the engine vs Gear Box code as it will have...
Results 1 to 25 of 56
Page 1 of 3 1 2 3
| |