I don't know about that, I'll be going for the wooden spoon :D
Type: Posts; User: hamza; Keyword(s):
I don't know about that, I'll be going for the wooden spoon :D
Pencil me in, will be running my daily, e30 318i, keen to see what it will make :D
If the wires run over the strut towers then yes please.
I didn't rewire the front. The photo I posted if off another car and is identical as to how my wires were.
Hi guys.
I am im slowly beginning to reassemble my 3dr vr swap and am having an issue with rewiring the engine bay. The donor vr was a early (94) 4 door car in dark red (maroon) and the 3 door...
I think the later cars came out with a carpeted boot. My 95 vr6 is bare like the op but my 97 cl has carpets covering sides and below tailgate.
Also i was told that the bumper on the vento is deferent in that it extends a little further forward, but no fitment issues.
The way you describe the car, 5 door CL, peeled clear (needs a full srepray as the paint now has faded due to failed clear) it is probably the most unwanted spec'c mk3 right now. The sentimental...
Imo you would be best off getting 25 or 50ml of paint from a paint supplier that can match the paint directly off your car as it probably has faded a little by now.
Also this thread is on page 333...
Hi guys, i have done some searching and was not able to get an answer, when performing a vr6 swap into a 1.8 cl, how much of the wiring do you swap over? All of it inc the fuses and behind the dash...
As far as i know, no they aren't. My vr compressor had a sticker saying 6 zylinder and the CL i parted out had a sticker 4 zylinder.
My 94 vr doesn't have a immobilizer but the 96 CL that i just parted out did. Its a ring that goes around the ignition barrel and accepts signals from a chip in the key. Cutting the key wasn't...
just don't do it yourself :D
https://www.youtube.com/watch?v=lKyqiGyu0Jk
Not a bad idea with the welding of the rear doors, the doors on my 2d are very long.
Yea i ordered obd2 parts, have fitted them already, will let people know how it goes.
obd 2 is a plug n play whereas obd1 has to be soldered in :(
do you know what exactly is required? and is that the only issue?
Will i have any issues if i fit them?
Hi guys, i am in the process of doing a timing chain service and accidentally ordered the later top guide rail and tensioner. I have since done some research and have found out that the new style...
Hi, i accidentally ordered these instead of the early style, so these are up for sale.
(if you have new early ones, please pm me)
asking $50 ono posted aus wide
...
Hi all, as the post states, i accidentally ordered the late vr parts (which will be in the for sale section).
let me know what you have.
your inbox is full..
I have one, pm me.
How much? (Borat voice)
Update:
I am about to order my parts hoard from ecs and have a question. Do i have the dual upper chain or the single?
heres a pic for ref and a pic of the engine number if that helps.
19685...
Sweet! i was just about to ask re the booster.
thanks