I have the AXD which also needed the water pump replaced, since then only the tandem pump and the high pressure fuel line that just split has worn out, otherwise these are the perfect low maintenance...
Type: Posts; User: BrianJ; Keyword(s):
I have the AXD which also needed the water pump replaced, since then only the tandem pump and the high pressure fuel line that just split has worn out, otherwise these are the perfect low maintenance...
Well done, I dread this happening to mine I've thought about spraying something into the lock, but haven't so far as I like to let sleeping dogs lie.
I have always wondered about the wisdom of putting that little cooler right behind the wheel. at least we have a mud flap there.
Mine had a perfect record until this weeks problem for faults that put you out of action. I have also fixed lots of things even the dip stick plastic top which was rubbish, the sliding window rods i...
Just before the Bribie Bridge I noticed that my rear window had gone cloudy, so kept going and parked just over the bridge. I could smell diesel fuel so had a look underneath and the entire...
The 2006 diesels used no pulleys and have direct gear driven drive to the external components, that is the coupling and rachet drive being referred to in the above posts. I have never seen a petrol...
I get most things done by German Autos at Geebung on the northside of Brisbane, they are trustworthy and do quality work.
Whatever you do, don't turn on the ignition while any fuses are out being checked. I did this to measure voltages trying to find out why all my dashboard lights are dull and caused a load of airbag...
Yes, I had reached desperate after an auto electrician near Kedron almost wrecked a loom and still didn't work out what was wrong. Even though I am wary of dealerships, they were able to source the...
Isn't that 30A SB9, SC9 the lower one is 5A and called 'Cruise control system switch'.
The light that should come on when it is turned on is in the 10 o'clock position of the tacho meter, on my beach that is the left and the speedo is the right. This video descibes a fault similar to...
I thought this through a bit more after posting, when the brake lights activate that will normally cancel any set speed, so for it to prevent the cruise from working the stop lights would have to be...
Almost anything can stop it working, a classic cause is a faulty brake light switch, that's the first thing I would check.
It looks like a horrific experience, I couldn't even watch it all. I will stick with my diesel.
My observation of mine is that if the locking pins that are activated by the centre flaps still work and go into the holes at the top and bottom, this ensures that the window is held firmly closed...
I've bought two before but only used the rear part and button covers, I kept using the old front part that the key is attached to. I suspect this isn't what you are wanting to do, so can't help I...
I was reading about it on the VW T5 Australia facebook group. Some people have managed to fix theirs temporarily using cable ties. Apparently you can take a cover off below the gearstick and see...
More than likely the gear stick linkage system.
Can you apply some sort of pressure test to the K2 clutch to make sure its faulty before dismantling the entire box.
My T5 was occasionally going into limp, and it had no error codes or alarms showing, and it ended up being caused by the auto gearbox controller. Resetting the controller fixed it completely. Never...
These are not like the original captains seats, if you remove a seat, the entire mechanism comes with the seat as one unit. That doesn't mean your example one won't work, but you will have to nut...
We have two factory swivel seats in our kombi beach, they both appear to mount onto the standard seat bases, which are simple metal ones that also came standard in the beach. The handbreak must be...
Thanks, I'm sure I could find it if I had the connecting leads. I don't think they could be bothered spending time on it.
So with this setting it would be possible to make my drivers door stay locked, if so, how is this setting accessed so I can ask my shop to set it.
No, I don't know how or if it can be corrected. I asked a shop nearby who know how to scan and do settings and they couldn't see anything wrong, so maybe there is different types of door locks.