Again, 10 years later but bingo
2 Pcs Rear Trunk Strap Sling Rope Holding Lanyard For VW Golf MK6 MK5 Rabbit GTI | eBay
I've just registered a decade in the future to say thank you for this part number!
I've been searching for these every few months since I bought my Mk5 four years ago - they're all but unobtainable in the US. I just bought several, and I'll finally have a parcel shelf that isn't crooked 😂.
Many thanks!
Again, 10 years later but bingo
2 Pcs Rear Trunk Strap Sling Rope Holding Lanyard For VW Golf MK6 MK5 Rabbit GTI | eBay
Nice listing, includes a photo of it installed of a Mk 4 MK4 had a neat retractable cord
MK4 GTI - Sold
MK5 Jetta Turbo - Sold
MK5 Jetta 2.Slow - Until it dies.
Same here, just registered to thank you and offer some alternate solution. If you have access to a 3D printer, here is a model that screws in the original mount without having to take any trim off : Print this
IMPORTANT:
- Print in ABS, PLA will likely soften, melt or bend if it gets hot in your car
- Print in the original orientation with supports (see picture on the model's page) = horizontal screw with vertical dome.
Worked like a charm for me!
Good luck!
hot glue gun is best or to do a proper job pull the section off and get a soldering iron or hot air gun and melt the plastic down not the easiest job as both half's of the tailgate trims have to come off and are not the best to get off or back on have seen them split at the boot latch area and the clips are hard to line up and get back in.
Nox Vidmate VLC
Last edited by mydanielcreg_3; 02-12-2022 at 06:59 PM.
Bookmarks