PDA

View Full Version : Transmission 02A repairer/rebuild in Melb ?


aussieg60
13-02-2006, 12:40 PM
Does any body know of a good repairer/reco for an 02A trans in Melb ?
Golf Loon
13-02-2006, 08:25 PM
Nope, but I have a few low kms 02a boxes :wink:
Tim
13-02-2006, 08:51 PM
what sort of dollars would u want for a decent 02A?
Golfwise
14-02-2006, 10:05 AM
Be sure you get a VR6 one Tim as the housings are different to the 4cylinder ones.
Have you got a mk3 16v one Loon I may want one once I've done some maths on ratios.
Golfwise
14-02-2006, 10:11 AM
Does any body know of a good repairer/reco for an 02A trans in Melb ?
Send it to Tassie and I'll do it. :D
aussieg60
14-02-2006, 06:23 PM
Some how a gear has jammed against this shaft as shown in the photo. I took a photo through the drive shaft flange hole. I have seperated the trans from the engine. When I put it in gear thats what had happened, it got jammed. Im not sure what to do, is it a complete overhaul ? How could the gear move ?
http://www.mygroovebox.com/gti/02AJam.jpg
Golf Loon
14-02-2006, 07:47 PM
I have 3 boxes. Codes are ata agc and csf. They are for 4 cylinders not VR6 and have hydraulic clutches. $1000 each.
DVR68U
14-02-2006, 11:14 PM
thats a pretty wierd problem. wouldnt think the gear could just move out of postion like that. is this out of a vr6 ?
aussieg60
14-02-2006, 11:34 PM
No, not a Vr6. Its from a G60 (ATA). The box has been sitting for some time, with no oil. I used to crank it round in neutral when it was attached to the engine.
Golfwise
15-02-2006, 11:58 AM
You would be looking at the diff going by your description .
Means a stripdown. :cry: