gman
16-02-2007, 02:32 PM
Getting frustrated!
Went to change the pads in the VR6.
Its a late '96 model so has the Teves ATA calipers.
Anyone know the size hex driver (allen key) needed to loosen the guide pins?
Its bigger than a 6mm and smaller than an 8mm (as I found out after putting the wheel back on, heading out to the hardware store and pulling the wheel off again).
Before I try to find a 7mm key, just wondering if it could be an imperial size??
Went to change the pads in the VR6.
Its a late '96 model so has the Teves ATA calipers.
Anyone know the size hex driver (allen key) needed to loosen the guide pins?
Its bigger than a 6mm and smaller than an 8mm (as I found out after putting the wheel back on, heading out to the hardware store and pulling the wheel off again).
Before I try to find a 7mm key, just wondering if it could be an imperial size??