flynhigh2007
11-12-2008, 11:28 AM
wel i'm going to be installing this ampprobably and was wondering do i need 4 guage wire or somehing thicker?
SMALL FOOTPRINT 500W MONO AMP XM1S
Output Power
CEA Rating: 280W x 1
DIN 45500 Rating (@ 14 V, THD 0.5 %)
4 ohm: 1 x 280W
2 ohm: 1 x 500W
Rated/THD (@ 14.4 V, 20 Hz - 20 kHz)
4 ohm: 1 x 290W / 0.2% (14.4V, 20 - 300Hz)
2 ohm: 1 x 500W / 1.0% (14.4V, 100Hz)
Maximum (@ 14.4 V)
4 ohm: 1 x 600W
2 ohm: 1 x 900W
Input
Low Pass Filter: 50-300Hz(Variable)
LPF Roll Off Rate: -12 dB/oct
Subsonic HPF , Roll Off Rate: Yes
Balanced Input Circuit: Yes
Input sensitivity: 0.3 - 6Volts
Output
Frequency Response: 5Hz - 300Hz
Tolerance: +0 / -3dB
Signal to Noise Ratio (@ Rated Power): 90dB
Total Harmonic Distortion (@1 kHz): 0.1%(50Hz)
CEA SN Ratio: 65dB
Min Load Impedance/Ch: 2 ohm
General
Illumination: Blue
Current drain (@ Rated Power - 4Ω): 30 Amps (at 4 ohm)
Weight (approx.)(kg): 2.3
Dimensions (WxHxD in mm) approx: 223x43.5x196
SMALL FOOTPRINT 500W MONO AMP XM1S
Output Power
CEA Rating: 280W x 1
DIN 45500 Rating (@ 14 V, THD 0.5 %)
4 ohm: 1 x 280W
2 ohm: 1 x 500W
Rated/THD (@ 14.4 V, 20 Hz - 20 kHz)
4 ohm: 1 x 290W / 0.2% (14.4V, 20 - 300Hz)
2 ohm: 1 x 500W / 1.0% (14.4V, 100Hz)
Maximum (@ 14.4 V)
4 ohm: 1 x 600W
2 ohm: 1 x 900W
Input
Low Pass Filter: 50-300Hz(Variable)
LPF Roll Off Rate: -12 dB/oct
Subsonic HPF , Roll Off Rate: Yes
Balanced Input Circuit: Yes
Input sensitivity: 0.3 - 6Volts
Output
Frequency Response: 5Hz - 300Hz
Tolerance: +0 / -3dB
Signal to Noise Ratio (@ Rated Power): 90dB
Total Harmonic Distortion (@1 kHz): 0.1%(50Hz)
CEA SN Ratio: 65dB
Min Load Impedance/Ch: 2 ohm
General
Illumination: Blue
Current drain (@ Rated Power - 4Ω): 30 Amps (at 4 ohm)
Weight (approx.)(kg): 2.3
Dimensions (WxHxD in mm) approx: 223x43.5x196