Dynamic Road Sign Display - VCDS/ODB11

[HiddenTaco]

I've confirmed this tweak is working

stolen from A guide to enable EU specific features for AU Spec Tiguans (http://www.vwwatercooled.com.au/forums/f238/guide-enable-eu-specific-features-au-spec-tiguans-117741.html)

1. Module 5F
Adaptations
Car_Function_List_BAP_Gen2 traffic_sign_recognition_0x21
Set to Active
Car_Function_Adaptations_Gen2-menu menu_display_road_sign_identification
Set to Enabled

Then go to Coding
Long Coding
Byte 24, activate Bit 6

2. Module A5

Then go to Coding
Long Coding
Byte 16, activate Bit 4

3. Module 17

Then go to Coding
Long Coding
Byte 5, activate Bit 2

Then you need to disable Road Sign Fusion.

4. Module A5
Adaptation
Road sign detection fusion mode
Change from Road sign fusion to Road sign detection

If you have HUD in your Tiguan, the following coding will enable speed signs to be shown on it (For NZ and other countries)

Module 82
Coding
Long Coding

Byte 0, Activate Bit 0.

Reboot the infotainment system.

[LRDV8R]

Does this tweak result in any error codes or warnings? I seem to recall reading somewhere that it creates a message appearing very time nav starts or similar or am I barking up the wrong tree?

[HiddenTaco]

Yes, once you drive up the road it will display a warning on the AID for a few seconds. The warning goes away on its own and is not intrusive.

The warning will show even if it picks up a sign and is showing it.

It works well regardless.

[LRDV8R]

Thanks, will give it a go!

[DreamensioN]

What's the warning message it gives?

[HiddenTaco]

34182

Top is the message that shows for a few seconds.
Buttom is what shows in the car status view.

[neveo71]

New to this can you explain to me how I do the long coding once I'm in there. There is a large number on top line with a series of smaller numbers beside it, under that is a line on left it says exmple byte 00 and right hex 2. Then a list of bit numbers what do you change to get the settings you are saying please.