ABS and handbrake lights on

[BambinoPolo2k]

howdy,
hey folks this is my 1st post here been away on military tour back home now
i recently replaced the abs power pump on my polo(6N2) however, to cut long story short after clearing the error cords
2 lights keep flashing on the dash.handbrake warning light plus ABS light

A trip to the auto shop had me rescan for more errors using VAG COM
We discovered the rear wheel speed sensor was faulty probably with dust.it was cleaned and replaced
The 2 lights are still flashing on the dash board. i was advised to find help and have the ABS re calibrated

Seeking help and advice on whether i can recalibrate a 6N2 abs system and with what scan tool
i have attached some photos showing the lights on the dash

Thank you
bambino

[h100vw]

A scan with a real VCDS lead might help. Purely guess work otherwise.

It has brake fluid doesn't it?

Gavin

[BambinoPolo2k]

A scan with a real VCDS lead might help. Purely guess work otherwise.

It has brake fluid doesn't it?

Gavin

i had the fluid flushed out using brake bleeder topped up with Bosch Barke fluid cost me an arm and a leg
had the car scanned using 3 diffrent scan tool; Launch Autoboss and VCDS on a laptop.All reported the same error code
the VCDS cleared all codes however the lights still flash on the dash

Bambino

[h100vw]

All reported the same error code
Bambino

Which was?

Gavin